Note (1)
d. Facility Page – System Alerts (Add New Alert)
Note (3)
Note (3a)
Notes 1. To add a new alert, click on “Add New Alert” after selecting a system. 2. Alerts are associated with any property data from the system – if something happens on the system, an alert can likely be tied to it. Sani-Matic will pre-load several common alerts but any custom alerts can be added. There are various types of alerts – some of the most common are: a. Analog Value Alerts i. Selecting analog values like temperature or conductivity can alert you when a value is below or above a certain value b. Event Alerts i. Event alerts can notify you of any event that occurs on the system, such as when a certain OpCode (Step) occurs, when a certain alarm occurs, when operators press certain buttons like “abort”, when hold values occur, or when cycles start/stop or are aborted. c. PM Alerts i. Preventive maintenance alerts can be setup so that you are notified when you are close to hitting your setpoint value on a component with a PM tracker. We recommend setting the PM value (e.g., “Cold Water Valve Cycles SP”) to 80-90% so that 3. Setup the alert by selecting a property to alert and entering in an “Alert Name”. a. NOTE: If the “Event” property is selected, the “View Event Table” pops up and you can see what the event # is for any event. The event # is needed for entering for alerting, so save the event # for the event you want to alert off of.
DM-0009_SaniTrend® Cloud CR_IOM_Rev2.0 DRAFT
40 of 51
Powered by FlippingBook