Jet Cleaner TANKO-JM
5. Remove the screwed parts from the vise.
6. Clamp the shaft-axle-connection (19) with the rotor shaft (15) and the preassembled parts in the vise.
7. Slide the base of the housing (03) with the screwed-on parts over the rotor shaft (15).
8. Screw the rotor impeller (16) on the rotor shaft (15) and tighten with the assembly/disassembly tool for rotor.
9. Screw and tighten the housing (02) on the base of the housing (03).
10.With the recess in the middle facing upward, guide the inflow disk (14) over the rotor shaft (15) and place it into the housing (02).
11. Connect bushing (04) over the rotor shaft (15) into the inflow disk (14) until it stops.
12. Place sliding disks (05, 06, 05) in sequence in the recess of the inflow disk (14).
13. Screw the slide cap (17) onto the rotor shaft (15) and tighten with a socket wrench.
14. Screw and tighten hexagonal nut (24) with spring ring (23) on the rotor shaft (15).
15. Check to ensure that the assembled nozzle fitting (20, 21, 22, 07, 09, 10) rotates freely around the rotor shaft (15).
16. Remove the screwed parts from the vise.
17. Clamp the housing (02) with the screwed-on parts in the vise.
18. Screw the connection cover (01) into the housing (02) and tighten it.
19. Press jet concentrators (12) in all nozzles (11) and nozzle extensions (13) and check that they are firmly in place. Remove the screwed parts from the vise. 20. Screw the nozzle extensions (13), together with the nozzles (08), into the nozzle carrier (22) and tighten them.
21. Remove the screwed parts from the vise.
The device is fully assembled and ready for installation (see section 5.2 Installation ) on the plant.
7 Maintenance
Translation of the original Operating / Installation Instructions 2016/12
69/90
Powered by FlippingBook