TANKO® S & TANKO® RB_IOM_Rev0

ATEX Spate Cleaner TANKO-EX-S and ATEX Spray Cleaner TANKO-EX-RB

1 Introduction

These operating/installation instructions (referred to hereinafter as the instructions) are a component part of the device. They provide you with all the information required for smooth operation of the TANKO ® EX-S/TANKO ® EX-RB cleaning system (referred to hereinafter as the device). The instructions must be read, understood, and applied by all persons employed to carry out installation and assembly, commissioning, maintenance, cleaning and troubleshooting on the device. This applies in particular to the listed safety instructions.

After studying the manual, you will be able to

– Assemble, install and operate the device safely

– Clean and service the device correctly

– Take the correct measures if a fault occurs.

In addition to these instructions, generally applicable, statutory and other binding regulations in regard of the prevention of accidents and in regard of environmental protection in the country of use must also be observed. The instructions must be kept at the location of use of the device so that they are available in legible condition at all times. If the device is resold, the instructions must always be transferred to the new owner.

Download the instructions if necessary from the http://www.awh.eu/de/downloads Internet page.

1.1 Means of Presentation

1.1.1 Explanation of Signal Words

The warnings are introduced with a signal word which describes the extent of the hazard. The meaning and their classification in case of hazardous situations are explained in the following overview.

Signal Word

Meaning

Consequences of Failure to Observe

DANGER

Hazard with a high level of risk Death or severe physical injury

Hazard with a medium level of risk

WARNING

Death or severe physical injury

CAUTION

Hazard with a low level of risk

Minor or moderate physical injury

NOTE

Hazard with a low risk

Risk of material damage

NOTE ON EXPLOSION PROTECTION

Important note on explosion protection

Loss of explosion protection and resulting hazards.

Table 1.1-1: Overview of Signal Words

1/79

1 Introduction

Translation-Operating/Installation Instructions 2017/10

Powered by