TANKO®-CP Jet Cleaner
7.4.4.1 Installing the TANKO-CP2 and CP2S device
The item numbers shown in brackets refer to the Picture 7.4-3: Exploded diagram of device. The tools required for assembly/disassembly work are listed in section 7.4.2 Tools and Tightening Torque Values.
1. Connect the collar bushing (5) to the housing (3).
2. Connect the plain bearing bushing (6) to the shaft (2). Make sure that the plain bearing bushing is flush with the bottom edge of the chamfer in the shaft (see arrow) so that cleaning agent can flow into the inside of the shaft (2) without obstruction (see Picture 7.4-6: Installation using assembly tool for plain bearing bushing CP2/CP2S ).
6
2
Picture 7.4-5: Position of the plain bearing bushing in the shaft
The assembly tool ensures that the plain bearing bushing (6) is pressed into the shaft (2) to the correct depth.
Assembly tool
6
2
Picture 7.4-6: Installation using assembly tool for plain bearing bushing CP2/CP2S
3. Push the sliding disk (7) onto the shaft (2).
4. Insert the shaft (2), together with the sliding disk (7), into the housing (3) and into the collar bushing (5) from above.
57/77
7 Maintenance Translation of the original operating/installation instructions 2016/10
Powered by FlippingBook