Installation & Operation The Magnetic Trap Strainer assemblies are used within Angle-Line Strainers and intended for standard flow processes (the process flows through the end-inlet and exits through the side-outlet). Perforated and wedgewire elements are suitable with standard flow processes, as are perforated elements with mesh overlays or filter tubes. For the full Angle-Line Strainer body and element installation instructions, please reference the Angle- Line Strainer IOM document (DM-0003). Assembly
The following instructions outline a 4” mag trap assembly – instructions for a 6” body are of a similar nature. Your O-Ring or Gasket material, or strainer element, may be different. For a video that shows retrofit and assembly of a mag trap, click on the below link or scan the below QR code.
[Sani-Matic Training] Magnetic Trap Strainer Retrofit
All pieces shown below must be present for a functional full Magnetic Trap Strainer Assembly.
Figure 1: Components of a 4” Magnetic Trap Strainer Assembly
DM-0006_Magnetic Trap Strainer IOM_Rev2.0
2 of 9
Powered by FlippingBook