Jet Cleaner TANKO-MX
7.3.1 Removing the Device Installation Opening of the Container
The use of the device (mobile or stationary) is the decisive factor for the required size of the installation opening. The specified installation dimensions in Table 3.3-1: Operating parameters of the device are recommended minimum dimensions for the installation opening and for installing the device in the container and removing it from the container in assembled condition. A “ stationary device ” can be removed in different ways depending on the properties of the container and the size and accessibility of the installation opening. – Before removal, the downpipe [DP] is disconnected from the process connection [PC] and lifted out of the container through the installation opening from the outside, together with the device. The device is then disconnected from the downpipe [DP] at the media connection [MC] or – the device is disconnected from the downpipe [DP] at the media connection [MC] inside the container.
WARNING Risk of the device falling accidentally! The device may strike personnel when falling. There is a risk of severe physical injuries. Hold the device firmly when installing/removing it. There must be nobody beneath the device when installing/removing it.
Interface A The supply line for the cleaning agent has to be disconnected at the media connection [MC]. The media connection [MC] has to be sealed with a screw cap. For threaded connection (see Figure 5.2-3: Threaded connection installation) : 1. Unfasten the connection cover threaded connection (01) / media supply pipe with an open-end wrench or an adjustable pliers wrench. 2. Unscrew the device from the pipe for the media supply. 3. Place the media connection [MC] with a suitable screw cap/sealing plug. Interface B NOTE Excessively small installation openings on the container! Risk of damage to the device or its surroundings. Before unfastening the process connection [PC], check whether the device can be lifted out through the installation opening of the container with the cleaning head (see section 3.3 Technical Data ). If the installation opening is too small, the instructions for interface “ C ” have to be observed.
46 / 86
Translation of the original operating/installation instructions 2016/03
7 Maintenance
Powered by FlippingBook