Jet Cleaner TANKO-MX
14. Remove the spur gear (18), together with the impeller (15) and the threaded pin (33) from the housing (02). 15. Unfasten the threaded pin (33) with a hexagon socket wrench size 2.5 mm and unscrew it from the impeller (15). 16. Push the impeller (15) from the shaft of the spur gear (18).
17. NOTE Incorrect clamping in the vise can cause threaded connections to become jammed and deformed unintentionally! The threaded connection cannot be screwed and may become damaged. The jaws of the vise must clamp too firmly and not directly in the area of the threaded connection being unfastened. Hold the housing (02) firmly with one hand and unfasten the vise. Fasten the housing (02) in a horizontal position in the vise so that the thread on the connection cover (01) is NOT clamped. 18. Place an open-end wrench/adjustable wrench on the flats of the connection cover (01), unfasten the connection cover (01) and unscrew it from the housing (02). 19. Lever the spiral circlip (29) out of the internal groove on the connection cover (01), by inserting the flat tip of a small screwdriver on the removal notch.
60 / 86
Translation of the original operating/installation instructions 2016/03
7 Maintenance
Powered by FlippingBook