TANKO® MX_IOM_Rev0

Jet Cleaner TANKO-MX

7.4.4.1 Assembling the MX125 Device

The item numbers shown in brackets refer to the Figure 7.5-1: Internal construction of the MX125. The tightening torque values for the screw connections required for assembly are listed in the Table 7.5-1: MX125 tightening torque values.

1) Assembly - Actuator Unit Assembly 1. Press the collar bushing (06) into the inflow disk (14).

2. Push the inflow disk (14) into the connection cover (01) so that the collar of the collar bushing (06) faces the inside of the device. 3. Insert the circlip (29) into the internal groove on the connection cover (01) and allow it to engage in place.

4. NOTE Incorrect clamping in the vise can cause threaded connections to become jammed and deformed unintentionally! The threaded connection cannot be screwed and may become damaged.  The jaws of the vise must clamp too firmly and not directly in the area of the threaded connection being unfastened.  Fasten the housing (02), with the spur gear (21) pressed in, in the vise in a horizontal position.

64 / 86

Translation of the original operating/installation instructions 2016/03

7 Maintenance

Powered by