TANKO® MX_IOM_Rev0

Jet Cleaner TANKO-MX

1 Introduction These operating/installation instructions (referred to hereinafter as the instructions) are a component part of the device. They provide you with all the information required for smooth operation of the TANKO ® MX jet cleaner (referred to hereinafter as the device). The instructions must be read, understood, and applied by all persons employed to carry out installation and assembly, maintenance, cleaning and troubleshooting on the device. This applies in particular to the listed safety notes.

After studying the instructions, you will be able to – assemble, install and operate the device safely, – clean and service the device correctly and – take the correct measures if a fault occurs.

In addition to these instructions, generally valid, statutory and other binding regulations in regard of the prevention of accidents and in regard of environmental protection in the country of use must also be observed. The instructions must be kept at the location of use of the device so that it is available in legible condition at all times. If the device is resold, the instructions must always be transferred to the new owner. Download the instructions if necessary from the http://www.awh.eu/de/downloads internet page.

1.1 Means of Presentation

1.1.1 Explanation of Signal Words The warnings are introduced with a signal word which describes the extent of the hazard. The meaning and their classification in case of hazardous situations are explained in the following overview.

Signal Word

Meaning

Consequences of Failure to Observe

Hazard with a high level of risk Hazard with a medium level of risk

Death or severe physical injuries

DANGER

Death or severe physical injuries

WARNING

Hazard with a low level of risk

Minor or moderate physical injuries

CAUTION

Hazard with a low risk

Risk of material damage

NOTE

Table 1.1-1: Overview of Signal Words

1 Introduction

Translation of the original operating/installation instructions 2016/03

1 / 86

Powered by