Mini retractor system TANKO-RF
7.4.2 Tools and Tightening Torques Use only proper tools that are required for performing the required work and approved for use. Normal workshop equipment is sufficient for the mechanical work on the device. The following tools are required: – Open-end wrench AF 36 and AF 24 mm for TANKO-RF40, AF 50 and AF 30 mm for TANKO-RF50 – or bigger and smaller (without illustration) pliers wrench – 2X torque wrench with socket shaft 14 x 18
– Jaw wrench insert AF 24 for TANKO-RF40 or adjustable pliers wrench insert – Jaw wrench insert AF 30 for TANKO-RF50 or adjustable pliers wrench insert – Articulated face wrench, small size
Figure 7.4-2: Tools for TANKO-RT/-RTS
Recommended assembly tools: The following assembly tools can be purchased from AWH to facilitate assembly: – Assembly tool for wire locking pin, see table
– Mounting bolt, art. no. see table – Mounting ring, art. no. see table
Figure 7.4-3: Assembly tool for wire locking pin
64/84
Operating/Installation instructions 2023/09
7 Maintenance
Powered by FlippingBook