Mini retractor system TANKO-RF
4. Pull the plate axle (2) with the axle center part (3) and the spray head (9) downwards out of the housing (1). 5. Bend the locking pin (5) open or pinch off a bent end. Remove the locking pin. Pull the plate axle (2) with spray head assembly (7, 8, 9) off the axle center section (3). 6. NOTE Make a note of the direction of rotation of the head Top view from axle plate direction (top)
Direction of rotation, TANKO-RF50
Direction of rotation, TANKO-RF40
Figure 7.4-6: Direction of Rotation of the Spray Head
Pull the spray head assembly (7, 8, 9) off the plate axle (2). 7. Press the plain bearings (7) and (8) out of the head.
8. Remove the O-ring (14) from the plate axle. 9. Remove the O-ring (15) from the housing. The device is now completely disassembled.
7.4.4 Mounting the Device
The tools required for assembly/disassembly work are listed in Section 7.4.2 Tools and Tightening Torques.
The item numbers shown in parentheses refer to Figure 7.4-5: Internal design of TANKO-RF40 and TANKO-RF50 .
Table 7.5-1 includes a list of spare parts.
The complete assembly is described below. If the device was not completely disassembled, start with the appropriate work step corresponding to the disassembly stage. NOTE Damage to the sealing surfaces must be prevented during disassembly and assembly.
7 Maintenance
Operating/Installation instructions 2023/09
67/84
Powered by FlippingBook