Mini retractor system TANKO-RF
1. Fit a new O-ring (14) on the plate axle (2). 2. Fit a new O-ring (15) on the housing. 3. Press the new plain bearings (7) at the top and (8) bottom into the spray head (9), while observing Figure 7.4-6: Direction of Rotation of the Spray Head . 4. Fit the spray head assembly (7, 8 and 9) with plain bearing (7), larger inner diameter (Ø10.1 for RF40 and 16.1 for RF50)) facing downwards on to the plate axle (2). 5. Plug the plate axle (2) and axle center section (3) together, align the clip holes with each other and push a new wire locking pin (5) through. NOTE Bend the locking pin so that it does not rub at any point when it is inserted into the housing (1) and the spring (10). 6. Insert the plate axle (2) with axle center section (3) and spray head assembly (7, 8 and 9) into the housing (1) from below. Slide the spring (10) over the axle center section (3) and screw on the axle cover (4) using a suitable tool. NOTE The axle cover is under tension due to the pressure spring when it is screwed on. We recommend using the mounting ring and the mounting bolt for tightening the screw connection, see Table 7.4-2: Assembly tools . 7. NOTE Incorrect clamping in the vise can cause threaded connections to become jammed and deformed unintentionally! The threaded connection cannot be screwed and may become damaged. • The jaws of the vise must not clamp too firmly and not directly in the area of the threaded connection. • Clamp the device in the vise in such a way on the housing (1) that the threaded connection on the cover (6) does NOT become jammed.
Screw the cover (6) into the housing (1) as far as it will go.
The device is now fully assembled and can be installed in the container.
68/84
Operating/Installation instructions 2023/09
7 Maintenance
Powered by FlippingBook