3.2 Structural Framing • Design: Open frame • Material: 316L/304 stainless steel angle • Surface Finish: 316L material to be 32µin Ra or better with non-wetted welds color cleaned and wetted welds ground and polished • 304 material to be mill finish and bead blasted • Fully welded single-piece construction • Five (5) hygienically sealed adjustable feet for locating the equipment at a fixed location in the facility. The adjustability allows the equipment to be leveled on uneven or sloped surfaces.
3.3 Sanitary Piping • Material: 316L stainless steel sanitary BPE tube and BPE fittings • Surface Finish: 32µin Ra ID / OD • Welding: Welds are performed manually per AWS D18.1 / D18.1M standards (latest edition). The weld interior is argon gas purged. • Weld Finish: As-welded ID / weld color removed OD • Slope: 1/8" per foot / 1.0% (GSD2) • Connections: Tri-clamp fittings with single hinged heavy-duty clamps with wing nuts
NOTE: • Based on product selections, other welding configurations are available (see Section 10.18 Weld Configuration )
• Gasket Material: EPDM 3.4 Electrical Conduit • Rigid Conduit: SCH 40 PVC • Flexible Conduit and Fittings: UL listed PVC with nylon fittings • Instruments requiring calibration are provided with extra cord to allow the device to remain connected and moved to a calibration cart 3.5 Pneumatics • Location: Instruments such as pressure regulators and solenoids are mounted inside the control panel. The air filter is located on the bottom of the control panel • Material: Interconnections within the control panel and pneumatic air lines from the control panel to the skid-mounted valves and equipment are run in a polyethylene tube
SANICAB ® PC CABINET WASHER TECHNICAL DATASHEET
Powered by FlippingBook