4.2) Leveling
Once the CyClean is placed in its final location, the height may need to be adjusted, and/or the CyClean may need to be leveled. The CyClean should be installed on a relatively flat, level surface. Failure to do so may result in issues that could affect the performance of the washer. These are generic leveling instructions intended for most installations. If your facility is not level, not flat, or has unique features, these leveling instructions might not be ideal for your specific installation. STEP 1: Start by measuring the distance between the floor and the cutout in the CyClean as shown below. Measurements should be taken on both sides. It is recommended that these distances be approximately 15-1/8” to 15-3/16” as a starting point. If adjustments need to be made, a 1-1/8” wrench can be used to loosen the jam nut, then a 14mm wrench can be used at the bottom of the foot to either raise or lower the CyClean.
19
Powered by FlippingBook