6.2) Understanding Part Modules Each Part Module will have installation requirements for how they should be properly installed onto a Modular Sanitation Cart. These requirements are identified on the respective Part Module webpage at CleanWorx.us. The most common requirement will be the number of slots required for installation. As discussed in section 6.1) Construction of a Sanitation Cart, the vertical uprights have a total of thirty-two (32) slots, sixteen (16) on either side of the Sanitation Cart. Each Part Module will take up at least one (1) of these slots but depending on the dimensions of the parts being placed on the Part Module, additional slots will be required. These additional slots may be above or below the Part Module. In some cases, additional slots may be required both above and below the Part Module. Basic Part Module Example Using the Buckets Part Module, shown below as an example, only one Part Module is required which uses one (1) slot for it to be installed, shown as the translucent blue rectangle and labeled SLOT #1. Parts placed onto this Part Module require up to three (3) additional slots above the Part Module, shown as translucent orange rectangles and labeled SLOT #2 through SLOT #4. In total, the Buckets Part Module will require a total of four (4) of the total slots available and can be installed on either the left or right side of the Sanitation Cart.
C35 Part Module - Buckets
CleanWorx ™ CyClean ™ 35 IOM
Powered by FlippingBook