Part Module Example with Installation Requirements The Baking Trays Part Module, shown below, is an example that shows a Part Module with several installation requirements. When compared to the Buckets Part Module, which uses one (1) Part Module, the Baking Trays Part Module requires four (4) identical Part Modules to function correctly. These Part Modules are designed to be symmetrical so they can be used as pairs on either side of the Sanitation Cart and also double as both the lower and upper supporting structure to hold full-sized baking trays. To start, two (2) Part Modules are required and are shown as the bottom-most translucent blue rectangles labeled SLOT #1. This and all other slot requirements are required in the identical slot on both the left and right sides of the Sanitation Cart. Baking trays placed onto the bottom-most Part Modules will require four (4) additional slots above them and are shown as translucent orange rectangles labeled as SLOT #2 through SLOT #5. Above that, two (2) more Part Modules are used to support the upper half of the baking trays, shown as the top-most translucent blue rectangles labeled SLOT #6.
C35 Part Module – Baking Trays
51
Powered by FlippingBook