DM-0018_CleanWorx™ CyClean™ 35_IOM_Rev1.3

9) TROUBLESHOOTING

9.1) Error Code Descriptions

The various error codes that can be displayed on the CyClean 35 are listed below. If there are any issues during operation that cause an error code to be displayed, use the items below as a starting point to resolve these issues. If your issues persist, obtain your machine’s serial number as noted in section 2.5) Serial Number Tag & Identification and contact your local representative.

E01 – Loss of Control Power Possible Cause

Solution

a) E-Stop pushbutton has been pressed

- Ensure E-Stop pushbutton is released, and that the reset

pushbutton has been pressed (if illuminated)

E02 – Loss of PLC Power Possible Cause

Solution

a) Initial power up of control panel Power to the PLC has been lost

- Acknowledge alarm - Consult wiring schematics to determine if PLC has power

E03 – Local E-Stop Pressed Possible Cause

Solution

a) E-Stop pushbutton has been pressed

- Release E-Stop pushbutton - Inspect or replace E-Stop pushbutton

E04 – Fill Hold Watchdog Possible Cause

Solution

a) Fill valve has been open for longer than the respective setpoint value and the level sensor is not detecting water

- Inspect water supply valve - Inspect or replace level sensor