Assembly Each Tanker Spray Washer assembly includes a top assembly (Items 1a / 1b) that is positioned onto the tanker manway. This top assembly is connected to the bottom TS-4 or TS-5 spray assembly by means of a clip (Item 9).
Figure 4: TS-5 Components
Figure 3: TS-4 Components
NOTE: The TS-5 includes an adapter kit (item 5) which sometimes can be inadvertently missed when unboxing the unit. This adapter is not applicable to TS-5 assemblies purchased prior to 2021.
Cleaning The bottom assembly of the TS-4 or TS-5 will self-clean during a Clean-In-Place (CIP) cycle that is run to clean the inside of the tanker that the unit is cleaning. It may be necessary to clean the manway gasket (Item 9) areas that are not directly in contact with the CIP solution. Wipe down or remove the manway gasket from the assembly and utilize Clean-Out-of-Place (COP) methods to periodically clean this gasket. Maintenance Gaskets will require periodic replacement. The frequency of gasket replacement will depend on the gasket material, operating conditions, process being cleaned, and CIP conditions. The TS-5 spray device will need to be re-built or replaced if rotation slows or stops.
DM-0016_Tanker Spray Washers_IOM_Rev2.0
7 of 8
Powered by FlippingBook