Jet Cleaner TANKO-JM
WARNING
Risk of burns from hot surfaces! The device may heat up significantly as a result of the cleaning fluid or the heat transfer from the container. Contact with the device can cause burns on the skin. There is a risk of death or severe physical injuries. Comply with the warning signs and DO NOT touch the indicated areas. Do NOT remove insulation from protected hot surfaces. Maintain safety clearance of existing protective equipment or barriers. Use protective equipment (e.g. protective gloves; cloths) to provide protection from the hot surface. Do not touch the device until after a sufficient cooling time. The safety systems and safety notes in the operating instructions for the higher-level plant/machine must be adhered to. The area around the plant/machine and the operator work stations at the plant/machine must be keep free of objects during operation so that unobstructed access is possible at all times. In order to ensure fault-free operation, the device must be treated with care at all times. When operating the device, adhere to the following additional instructions: WARNING Persons in the container. A person may be struck by the jets from the cleaning head! There is a risk of death or severe physical injuries. DO NOT start cleaning operation while there are persons in the container. NEVER direct the cleaning jet at persons. WARNING Incorrect operation of the device! There is a risk of death or severe physical injuries. Only operate the device when it is in perfect condition. Do not operate the device unless it is installed inside an enclosed container. Drain and depressurize the container being cleaned. Close all of the openings on the container (e.g. inspection openings). When operating the device, adhere to the switch-on and switch-off procedures (see sections 6.3 Switch-on Procedure and 7.2 Switch-off Procedure ). There is no need for the device to be run in. The following operating states of the device are NOT permitted:
– Operation of the device without cleaning agent.
– Immerse the device in the product of the production process.
– Operation of the device outside the permitted parameters (see section 3.3 Technical Data ). Immediately stop operation in the event of leaks outside the container.
Refrain from any type of work which compromises the safe and reliable function of the device. Immediately inform the operating company of any changes to the device or the plant that may impair its safety.
6 Commissioning
Translation of the original Operating / Installation Instructions 2016/12
45/90
Powered by FlippingBook