Jet Cleaner TANKO-JM
7.4.1.1 JM100 Maintenance Intervals
Maintenance points
A Media connection [MC] / Process connection [PC]
B Plain bearing on rotor shaft
C Housing / bevel gear wheel connection
D Nozzle carrier / nozzles connection
E Plain bearing on axis for nozzle carrier
Figure 7.4-1: JM100 maintenance points
The tightening torque values for the thread connections required for maintenance are listed in section 7.5.1 JM100 Spare Parts.
Inspection and Maintenance Work
A The fluid and process connection is implemented using a threaded connection. Vibrations from operation could under certain circumstances cause the connection to become loose. You must therefore regularly check to see if they are firmly in place.
m
S, F
B Check plain bearing to make sure it is fully functional and for wear. Clean or replace the plain bearing washers as necessary.
200 h O
S, F, R
C The housing/bevel gear wheel connection is implemented via a threaded connection. Check the secure placement and functionality of the bevel gear wheel (rotation) and the wear on the teeth. m S, F
D Check the nozzle carrier / nozzles connection to make sure that it is securely in place.
m
S, F
E Check the ball bearings to make sure they are fully functional and for wear. Clean or replace the balls as necessary.
200 h O
S, F, R
Table 7.4-1: JM100 inspection and maintenance work
54/90
Translation of the original Operating / Installation Instructions 2016/12
7 Maintenance
Powered by FlippingBook