Jet Cleaner TANKO-JM
Inspection and Maintenance Work
A The fluid and process connection is implemented using a threaded connection. Vibrations from operation could under certain circumstances cause the connection to become loose. You must therefore regularly check to see if they are firmly in place.
m
S, F
B Check plain bearing to make sure it is fully functional and for wear. Clean or replace the plain bearing washers as necessary. C Check plain bearing to make sure it is fully functional and for wear. Clean or replace the plain bearing washers as necessary.
200 h O
S, F, R
200 h O
S, F, R
D The housing/bevel gear wheel connection is implemented via a threaded connection. Check the secure placement and functionality of the bevel gear wheel (rotation) and the wear on the teeth. m S, F
E Check the nozzle carrier / nozzles connection to make sure that it is securely in place.
m
S, F
F Check plain bearing to make sure it is fully functional and for wear. Clean or replace the plain bearing washers as necessary.
200 h O
S, F, R
G A thread is used to connect the bevel gear wheel to the nozzle carrier. Check the secure placement and functionality of the bevel gear wheel (rotation) and the wear on the teeth. m S, F
Table 7.4-3: JM800 inspection and maintenance work
7.4.2 Tools and Tightening Torque Values
Use only proper tools which are required for performing the required work and approved for use.
Standard workshop equipment and the special tools listed are sufficient for performing mechanical tasks on the device. The following tools are required:
– Screwdriver set (slot head)
– Hexagon socket wrench (WAF 2; 3 mm)
– Set of socket wrenches (WAF 28; 38 mm)
– Open end / box wrench set (WAF 12; 16; 22; 28; 32; 38; 48; 54; 75 mm)
– Pliers wrench or adjustable wrench / crescent wrench with smooth parallel jaws
14 x 18
– Torque wrench with socket shaft
– Torque screwdriver with inserts and accessories
– Strap wrench/belt pipe wrench (e.g. Ø 140) with woven belt – Square bar 10 x 10 – 300 mm for JM 500
All the screw connections on the device are firmly tightened in the factory with a corresponding tightening torque. This ensures that the required clamping force between the components to be joined is also present during the time of maximum application of operating forces. All the relevant tightening torque valued for the screw connections are listed in section 7.5 Spare Parts and Customer Service.
7 Maintenance
Translation of the original Operating / Installation Instructions 2016/12
57/90
Powered by FlippingBook