ATEX Spate Cleaner TANKO-EX-S and ATEX Spray Cleaner TANKO-EX-RB
Type representative TANKO-EX-S with assembled locking pin
Wire locking pin as delivered
Figure 5.2-5: Clip-on Installation
NOTE Multiple utilization of the wire locking pin. The material experiences fatigue and loses its rigidity when the wire locking pin is subjected to multiple bending. The wire locking pin may come loose.
The device and the wire locking pin could fall into the container.
The wire locking pin is to be replaced by a new wire locking pin after it has been bent (see section 7.5.1 Spare Parts ).
NOTE Non-compliance with the dimensions for media connection (see Table 5.2-2: Dimensions clip-on ) Problems with the fastening of the device to the downpipe could be the result. The distance between the bore hole for the clip in the downpipe and the end of the downpipe may not exceed a maximum of h1 – h2.
The bore hole diameter for the clip in the downpipe has a diameter of d.
1. Slide the device connection over the downpipe and rotate it until the clip bore holes in the downpipe match the clip boreholes of the device. 2. Insert the wire locking pin through the bore holes in the downpipe and the device until it hits the stopper. 3. Bend the straight end of the wire locking pin with the assembly/disassembly tool for the locking pin by at least 45° (see Figure 5.2-5: Clip-on Installation ).
39/79
5 Installation
Translation-Operating/Installation Instructions 2017/10
Powered by FlippingBook