ATEX Spate Cleaner TANKO-EX-S and ATEX Spray Cleaner TANKO-EX-RB
7 Maintenance
The following safety instructions apply to all work on the device that is listed and described in this chapter, and must be observed at all times. Use only original spare parts when replacing parts of the device. A functional check must be performed after every repair (see section 6.2 Functional Check / Trial Run ).
WARNING
Risk of accident caused by incorrectly performed maintenance and repair work! Improper maintenance, falling components or failure to adhere to the listed safety instructions can lead to accidents. There is a risk of death or severe physical injury.
Allow only experts to perform work on the device.
Do not work on the device unless it is insulated from electrical voltage, depressurized and in a cool state.
Maintain a safe distance when working on the device.
We recommend that you provide 1 m of space for free movement around the device and container.
7.1 Safety Instructions for Maintenance
NOTE ON EXPLOSION PROTECTION Work on the device in an explosive atmosphere is PROHIBITED! Non-compliance can result in the loss of explosion protection.
Only allow instructed personnel to work in potentially explosive atmospheres.
The personal protective equipment must satisfy the requirements of explosion protection.
Do not use a tool that could create sparks.
DANGER
Fatal shock hazard through contact with live parts! Activated electrical components are live with dangerous electrical voltage and may perform uncontrolled movements. There is a risk of death or severe physical injury.
Allow only qualified electricians to perform work on the electrical system.
Before starting work, observe the working steps of the switch-off procedure (see section 7.2 Switch-off Procedure).
Cover adjacent live parts to prevent contact.
Beware of the hazards caused by electrical current (e.g. warnings).
49/79
7 Maintenance
Translation-Operating/Installation Instructions 2017/10
Powered by FlippingBook