Jet Cleaner TANKO-MX
12. Lever the spiral circlip (31) out of the internal groove on the driver shaft (25), by inserting the flat tip of a small screwdriver on the removal notch, and screw it out in a spiral pattern. 13. Pull the bevel gear wheel for the nozzle carrier (26) from the driver shaft (25). 14. The cylindrical pin (35) is pressed into the driver shaft (25) and should not be removed.
15. Pull the bushing (09) from the shaft-axle connection (24) with a set of pliers or lever it out with the flat tip of a small screwdriver. 16. Unfasten the threaded pin (34) on the drift of the shaft-axle connection (24) with a hexagon socket wrench size 2.5 mm and unscrew it.
17. Hold the device firmly with one hand and unfasten the vise. 18. Fasten the device vertically in the lower area of the shaft-axle connection (24) so that the connection cover (01) faces upwards and the thread for the bearing plate (28) of the shaft-axle connection (24) faces to the side.
56 / 86
Translation of the original operating/installation instructions 2016/03
7 Maintenance
Powered by FlippingBook