Jet Cleaner TANKO-MX
2) Disassembly - Actuator Unit Assembly
Before you can start with disassembly of the actuator unit assembly, the cleaning head assembly unit first has to be removed.
1. NOTE Incorrect clamping in the vise can cause threaded connections to become jammed and deformed unintentionally! The threaded connection cannot be screwed and may become damaged. The jaws of the vise must clamp too firmly and not directly in the area of the threaded connection being unfastened. Fasten the actuator unit assembly in the vise in a horizontal position on the housing (02) so that the threaded connection for the bevel gear wheel for the housing (23) is NOT clamped. 2. Lever the spiral circlip (30) out of the internal groove on the housing (02), by inserting the flat tip of a small screwdriver on the removal notch, and screw it out in a spiral pattern. 3. Unfasten the bevel gear wheel for the housing (23) with an adjustable face wrench (pin Ø 3 mm) and unscrew it from the housing (02).
4. Push the bevel gear wheel for the housing (23) with the plain bearing (10) from the spur gear (22). 5. Support the bevel gear wheel for the housing (23) on a surface so that the plain bearing (10) is exposed. 6. Use an auxiliary tool (e.g. drift) to drive the plain bearing (10) from the bevel gear wheel for the housing (23).
58 / 86
Translation of the original operating/installation instructions 2016/03
7 Maintenance
Powered by FlippingBook