Jet Cleaner TANKO-MX
5. Screw the connection cover (01), together with the collar bushing (06), inflow disk (14) and circlip (29) in the housing (02), and tighten it.
6. Hold the screwed parts firmly with one hand and unfasten the vise. 7. Fasten the screwed parts on the outer diameter of the housing (02) in the thread area of the connection cover (01) in the vise in a vertical position so that the opening is facing upwards. 8. Push the impeller (15) onto the shaft of the spur gear (18).
9. Screw the threaded pin (33) into the impeller (15) and tighten it with a hexagon socket wrench size 2.5 mm. 10. Insert the spur gear (18), together with the impeller (15) and the threaded pin (33), through the opening in the housing (02) and push the shaft end with the slot into the collar bushing (06).
7 Maintenance
Translation of the original operating/installation instructions 2016/03
65 / 86
Powered by FlippingBook