Jet Cleaner TANKO-MX
2) Assembly - Cleaning Head Assembly Unit
Before you can start with assembly of the cleaning head assembly unit, the actuator unit assembly first has to be assembled.
On the cleaning head, there is a “ bore for self-cleaning ” of the device on the face of the nozzle carrier. This bore is also used for orientation when disassembly/assembly of the device. The position of the “ bore for self-cleaning ” is denoted by the symbol in the illustrations. 1. NOTE Screw in the nozzle (12) directly at the “ bore for self-cleaning ” until after installing the nozzle carrier (27) on the device and then tighten it. Repeat the following steps in accordance with the number of nozzles (12) on the device: Fasten the nozzle carrier (27) in the vise. Push the jet concentrator (13) into the nozzle (12). Screw the nozzle (12), together with the jet concentrator (13), into the nozzle carrier (27) and tighten it. Remove the nozzle carrier (27) from the vise.
2. Fasten the shaft-axle connection (24) in the vise so that the dome faces upwards and the thread for the bearing plate (28) faces to the side. 3. Insert the collar bushing (07) into the shaft-axle connection (24).
68 / 86
Translation of the original operating/installation instructions 2016/03
7 Maintenance
Powered by FlippingBook