Jet Cleaner TANKO-MX
18. Screw the nozzle carrier (27), with the nozzles (12) and jet concentrator (13), onto the driver shaft (25) and tighten it with a belt wrench.
19. NOTE The threaded pin (34) may fall into the device when being screwed in! Risk of damage in the device from foreign bodies. If a threaded pin (34) falls into the device during assembly, it must be removed. Place the threaded pin (34) on the hexagon socket wrench, size 2.5 mm. Insert the hexagon socket wrench with the threaded pin (34) through the threaded bore directly next to the “ bore for self-cleaning ” on the face of the nozzle carrier (27). Screw the threaded pin (34) into the nozzle carrier (27) crossways to the driver shaft (25) and tighten it. 20. Screw the nozzle (12) with the jet concentrator (13) into the nozzle carrier (27) and fasten it.
21. Remove the device from the vise.
3) Inspecting the Assembly 1. Hold the device firmly with one hand and turn the spur gear (18) at the shaft end with a slotted screwdriver.
The actuator shaft can be rotated but only with noticeable resistance. There is an error in the assembly. Disassemble the device and correct the error. The spur gears of the gear unit probably have not been joined correctly during assembly. The actuator shaft rotates smoothly without resistance. The device is fully assembled and ready for installation (see section 5.2 Installation ) on the plant.
7 Maintenance
Translation of the original operating/installation instructions 2016/03
71 / 86
Powered by FlippingBook