ATEX Spate Cleaner TANKO-EX-S and ATEX Spray Cleaner TANKO-EX-RB
Base Material
Suitable Filler Material
1.4435
1.4430, 1.4440
2.4602
2.4607
Table 5.2-1: Recommended Filler Materials
3. Welding
– Before welding, connect the forming gas.
– Before welding, affix 3 to 4 tack weld-ons.
4. Welding Post-Treatment
– In the interior area, an acid cleaning treatment is recommended after the welding.
– The surface of accessible points can be improved by grinding.
– The exterior can be treated afterwards by staining, brushing, grinding and polishing.
– After welding, thoroughly rinse the downpipe with the device to remove residues from welding and after-treatment.
5. Install downpipe with device in the container.
Installation threaded connection
1 Do NOT place the strap wrench/belt pipe wrench in the ball bearings area
1
Figure 5.2-3: Installation threaded connection
1. Push the device with the interior thread onto the pipe for the media supply.
NOTE There is a risk of damage to the thread if the tightening torque applied to the threaded device connection and the pipe is excessive! The tightening torque value between the threaded device connection and the pipe depends on the material of the pipe for the media supply.
37/79
5 Installation
Translation-Operating/Installation Instructions 2017/10
Powered by FlippingBook