ATEX Spate Cleaner TANKO-EX-S and ATEX Spray Cleaner TANKO-EX-RB
7.4.2 Tools and Tightening Torque Values
Use only proper tools which are required for performing the required work and approved for use.
NOTE ON EXPLOSION PROTECTION When working in areas where flammable or easily ignitable vapors, liquids or dusts are present, where sparks could result in a potential fire or explosion hazard, tools that are unlikely to create sparks should be used. Non-compliance can result in the loss of explosion protection.
Do not use a tool that could create sparks.
When working in an explosive atmosphere, it is important to remember that possible sparking is influenced can be caused by factors other than the tool. E.g.:
The material to be processed
–
– The hardness of the material to be processed compared to the hardness of the tool
– The impact or friction energy applied
– Additional, existing deposits that could cause sparking, such as rust, aluminum, combustible dusts and the amount of oxygen.
The following tools/special tools are sufficient for mechanical work on the device.
Screwdriver set (slot head)
–
– Open end / box wrench set (WAF 12; 16; 22; 28; 32; 38; 48; 54; 75 mm)
– Pliers wrench or adjustable wrench / crescent wrench with smooth parallel jaws
–
– Torque screwdriver with inserts and accessories
– Strap wrench/belt pipe wrench (e.g. Ø 140) with woven belt
Special Tools
Assembly/disassembly tool for locking pin (clip-on):
Art. no. 664 MW0 101 005 0 size A for wire Ø 2.0 mm
Art. no. 664 MW0 102 005 0 size B for wire Ø 2.4 mm
Art. no. 664 MW0 103 005 0 size C for wire Ø 3.6 mm
Art. no. 664 MW0 104 005 0 size D for wire Ø 4.5 mm
59/79
7 Maintenance
Translation-Operating/Installation Instructions 2017/10
Powered by FlippingBook