TD-0001_COP Parts Washers_Technical Datasheet_Rev6.0

CLEAN-OUT-OF-PLACE (COP) PARTS WASHER

The following are the manufacturers and models of the components used in the assembly of this equipment. Note that inclusion of certain components is dependent on the type of model options selected. 6 COMPONENT MANUFACTURERS

TABLE 3: COMPONENT MANUFACTURERS

Component

Manufacturer

Model

Pump

Ampco

AC

Valve, Butterfly

VNE

51 Series

Valve, Control (steam) Conductivity Sensor Conductivity Analyzer

Watson McDaniel / Trerice

W91 / D Series

Rosemount Rosemount Anderson ifm Efector ifm Efector Glo-Quartz

225

1056

Chart Recorder

AJ-300

RTD

TM TD

Temperature Transmitter

Electric Heater Chemical Pump

-

Wilden

P1

7 GENERAL EQUIPMENT DESCRIPTION

7.1 TANK • The tank is used to hold chemical wash solutions. All wash solutions are supplied to the tank’s jets or manifolds from the circulation system which draws the wash solutions from the tank. A sump strainer (bead blast finish) with 1 / 8 " perforations is located at the outlet of the tank to protect the pump and jets. The components being washed are placed in the tank, either loose or in baskets, and submerged in the wash solutions. • Design Features: ο Sides: 12 ga. ο Bottom Head: 12 ga. ο Insulation: None ο Overflow: None ο Design: Atmospheric ο Material: 304ss wetted surfaces ο Interior Finish: 32 µin Ra with welds ground smooth (strainer insert, tank trough, etc. may have other finishes) ο  Exterior Finish: Bead blasted • Standard equipped side jet manifolds create rolling agitation within the tank and are best for washing small parts and fittings. The jets are of a sanitary design being fully welded to the tank and the supply manifold. • The UW, RW, and TW series tanks have dual side jets, while the deeper PW series tanks have quad side jets.

8

CLEAN-OUT-OF-PLACE (COP) PARTS WASHER TECHNICAL DATASHEET

Powered by