4. Utility Requirements
The minimum required utilities for the proper operation of the equipment are listed in Table 1 If these utilities are not available, an Alternative Design Requests may be required
Table 1: Utility Requirements
Potable Water
Drain
Steam Supply Approximate Time (min) for Full Tank Heat Up (55 ° F to 140 ° F)
Electrical
Tank Series and Length
Tank Fill (gallons)
Connection Size / Type
Load @ 50 psi (lbs/hr)
Connection Size / Type
Amps @ 230V AC
Amps @ 460V AC
UW04 UW06 UW08
62
20" TC 20" TC 25" TC 25" TC 25" TC 25" TC 25" TC 25" TC 30" TC 30" TC 25" TC 25" TC 30" TC 30" TC 30" TC 25" TC 25" TC 30" TC 30" TC 30" TC
377 377 742 742 742 377 742 742
12 12
050" FNPT 050" FNPT 075" FNPT 075" FNPT 075" FNPT 050" FNPT 075" FNPT 075" FNPT 100" FNPT 100" FNPT 075" FNPT 075" FNPT 100" FNPT 100" FNPT 100" FNPT 075" FNPT 075" FNPT 100" FNPT 100" FNPT
70 70
35 35 60 60 90 60 60 90
91
120 149
8
120 120 180 120 120 180 360 360
UW10
10 10
UW12
178
RW04 RW06 RW08 RW10 RW12 PW04 PW06 PW08
95
12
140 185 230
9
12
1,272 1,272
9
180 180
275
11
138
742 742
9
120
60 90
203 267 332 397
13
180
1,272 1,272 1,272
10 13 15
360 360 360
180 180 180
PW10
PW12
TW04 TW06 TW08 TW10 TW12
132
742 742
9
120
60 90
195
13
180
257
1,272 1,272 1,272
10
360 360 360
180 180 180
319
12
382
15
100" FNPT
NOTE: • Listed amp draws are for Ampco supply pumps Other manufacturers may vary slightly See Table 4 for all pump and HP values All pumps are 230/460V AC dual rated See Section 10.8 (Table 6) for disconnect size when selecting a controls package • Drain temperature is variable based on COP cycle • Steam Supply requirement is based on selection of the standard in-tank steam sparger • Chemical requirement is dependent on cleaning process
sanimatic.com 5
TD-0001.3.0
Powered by FlippingBook